The brake lever is mounted with a clamp around the handlebars, so you decide exactly where the brake should be located.

It's a Shimano I-Spec EV lever that makes it compatible with the Shimano I-Spec EV shift lever, so the shift lever sits alongside the brake for a cleaner cockpit.

The clamp is moved in the middle of the brake and further out towards the handle itself, the brake supports the handlebars. It makes the brake 10% stiffer according to Shimano.

It gives you a better opportunity to modulate the pressure, so you ensure the best control by not blocking the wheel by mistake.

The brake is operated with just one finger, so you can focus on the track ahead.

The brake caliper responds more quickly to the pressure in the grip, and therefore brakes faster. The pistons also retract faster. This means that you need less time to brake, so you can get the most out of the bike.

The caliber is better at emitting heat than its predecessor, and this can be further increased by using brake pads with heat sink.

It is for postmount mounting.

The technology in the entire brake set is similar to that used in both XT. However, the choice of material is different, which makes the brake heavier and the modulation is not quite as good as it is in the XT M8100.

However, not everyone can feel the difference, precisely because the technology is so well developed.

There is a 1000mm hose so you can reach the rear brake on all regular bikes.

It comes assembled and ready for mounting.

If the cable needs to be shortened to fit optimally on your bike, fittings are included so you can shorten it at home.